No Ipv6 Dhcp Client Information Refresh Minimum - Siemens SCALANCE XM-400 Configuration Manual

Result
The interval is specified. When the time elapses, the DHCPv6 client sends an information
request message to refresh the configuration parameters.
Further notes
You enable the function DHCPv6 client with the
You display the setting with the
You configure the setting with the
command.
7.4.2.3

no ipv6 dhcp client information refresh minimum

Description
With this command, you reset the interval to the default value.
Requirement
● DHCPv6 Is activated.
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
no ipv6 dhcp client information refresh minimum
Result
The interval is reset.
Further notes
You enable the function DHCPv6 client with the
You configure the interface as a router port with the
You display the setting with the
You configure the interval with the
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
ipv6 address dhcp
command.
show ipv6 dhcp
ipv6 dhcp client information refresh minimum
ipv6 address dhcp
no switchport
command.
show ipv6 dhcp
ipv6 dhcp client information refresh minimu
Network protocols
7.4 DHCPv6 client (IPv6)
command.
command.
command.
command.
339