No Ip Igmp Version - Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.2 IGMP
Syntax
Call up the command with the following parameters:
ip igmp version {1 | 2 | 3}
The parameters have the following meaning:
Parameter
1
2
3
Result
The version of IGMP used by the device is specified.
Further notes
You can reset the version to the default with the
You display the setting and other information with the
command.
8.2.3.20

no ip igmp version

Description
With this command, you reset the IGMP version back to the default value.
Requirement
You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call the command without parameter assignment:
no ip igmp version
Result
The version is reset.
Further notes
You configure the IGMP version with the
You display the setting and other information with the
command.
456
Description
Version 1
Version 2
Version 3
ip igmp version
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
-
Default
-
command.
no ip igmp version
show ip igmp global-config
command.
show ip igmp global-config
Configuration Manual, 06/2016, C79000-G8976-C252-11