Dcp Forwarding - Siemens SCALANCE XM-400 Configuration Manual

Further notes
You configure the static IPv4 address with the
You display this setting and other information with the
You enable DHCP with the
7.1.3.4

dcp forwarding

Description
With this command, you configure the forwarding behavior of the interface for DCP frames.
Note
PROFINET configuration
Since DCP is a PROFINET protocol, the configuration created here is only effective with the
VLAN associated with the TIA interface.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
dcp forwarding {block|forward}
The parameters have the following meaning:
Parameter
block
forward
Result
The forwarding behavior of the interface for DCP frames is configured.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
ip address
command.
ip address dhcp
Description
DCP frames are discarded
DCP frames are forwarded
Network protocols
7.1 IPv4 protocol
command.
command.
show ip interface
Range of values / note
-
Default:
forward
305