No Ip Echo-Reply; Ip Domain Used Server - Siemens SCALANCE XM-400 Configuration Manual

Result
"ICMP echo reply messages" are enabled. The network node reacts to ping queries.
Further notes
You disable the setting with the
7.1.2.4

no ip echo-reply

Description
With this command you stop the network node reacting to ping queries.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ip echo-reply
Result
"ICMP echo reply messages" are disabled. The network node does not react to ping queries.
Further notes
You change the setting with the
7.1.2.5

ip domain used server

Description
This command specifies which DNS server the device uses.
Note
Only resource records of type A (IPv4 address of a host) are supported.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
no ip echo-reply
command.
ip echo-reply
Network protocols
7.1 IPv4 protocol
293