Commands In The Interface Configuration Mode; Spanning-Tree - Siemens SCALANCE XM-400 Configuration Manual

Result
The selected setting for the time is reset to the default value.
Further notes
You configure the time with the
You display these settings and other information with the commands that start with

spanning-tree ...

6.3.5

Commands in the interface configuration mode

This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
Global configuration mode.
● If you exit the Interface configuration mode with the
Privileged EXEC mode.
6.3.5.1 spanning-tree
Description
With this command, you configure the various properties of the spanning tree function:
● With the
● With the
● With the
segment. The following settings are possible:
–
–
● With the
is connected to an end device and can therefore ignore the waiting time before changing
to Forwarding mode.
● With the
spanning tree configuration.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
.
option, you configure the port costs used to calculate the lowest-cost path.
cost
option, you disable the interface for the spanning tree function.
disable
option, you configure the connection status of the following network
link-type
– the interface communicates with precisely one network component
point-to-point
- the interface is connected to more than one network component
shared
option, you enable the PortFast function on the interface. The interface
portfast
option, you configure the priority of the interface for negotiating a
port-priority
command (time settings).
spanning-tree
command to change to this mode.
interface
Network structures
6.3 Spanning Tree
command, you return to the
exit
command, you return to the
end
show
257