Ipv6 Interface-Identifier - Siemens SCALANCE XM-400 Configuration Manual

Syntax
Call the command without parameter assignment:
ipv6 enable
Result
IPv6 is enabled.
Further notes
You configure an IPv6 address with the
You display this setting and other information with the
You enable IPv6 routing with the ipv6 unicast-Routing command.
7.2.4.9

ipv6 interface-identifier

Description
With this command, you configure the interface ID. The interface ID uniquely identifies the
IPv6 interface on the link. Along with the prefix, the interface ID forms the IPv6 address, see
Structure of an IPv6 address (Page 51).
Requirement
● DHCPv6 Is activated.
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ipv6 interface-identifier <prefix>
The parameter has the following meaning:
Parameter
prefix
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Interface ID
command.
ipv6 address
show ipv6 interface
Range of values / note
Enter an interface ID.
Maximum 64 bits
Network protocols
7.2 IPv6 protocol
command.
327