No Rate-Limit Output - Siemens SCALANCE XM-400 Configuration Manual

The parameters have the following meaning:
Parameter
rate-value
If you do not select any parameters from the parameter list, the default value is used.
Result
The limitation of the outgoing data stream of the interface with the data rate is enabled.
Further notes
You disable the function with the
10.1.2.2

no rate-limit output

Description
With this command, you disable the data rate for limiting the outgoing data stream of the
interface.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no rate-limit output
Result
The limitation of the outgoing data stream of the interface with the data rate is disabled.
Further notes
You enable the function with the
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Value for the in data rate in Kbps
no rate-limit output
rate-limit output
Range of values / note
Default:
The data rate is set to 0. The
outgoing data stream is not lim-
ited.
command.
command.
Load control
10.1 Rate control
777