No Ipv6 Address - Siemens SCALANCE XM-400 Configuration Manual

You display the IPv6 address of the DHCP PD sub-client with the
interfaces.
You enable prefix delegation with the
You enable stateless DHCPv6 autoconfiguration with the ipv6 address dhcp stateless
command
7.2.4.2

no ipv6 address

Description
With this command, you delete the IPv6 address.
Requirement
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
no ipv6 address <prefix> <prefix Len> [{unicast | anycast | eui64}]
The parameters have the following meaning:
Parameter
prefix
prefix Len
unicast
anycast
eui64
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The IPv6 address has been deleted.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
Description
IPv6 address
Number of bits belonging to the prefix
(from left to right)
Addressing mode unicast
Addressing mode anycast
Interface ID according to the EUI-64
method
command.
ipv6 address dhcp
Range of values / note
Enter a valid IPv6 address.
1 ... 128 bits
64: With EUI-64
128: The node (host) and with link-
local addresses
-
-
-
Network protocols
7.2 IPv6 protocol
show ipv6 dhcp sub-client
321