Area Virtual-Link - Siemens SCALANCE XM-400 Configuration Manual

Parameter
advertise
not-advertise
Translation
enabled
disabled
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The address range is configured.
Further notes
You delete the address range with the
You configure the area with the
You can display the status of this function and other information with the
summary-prefix
9.3.3.7

area virtual-link

Description
With this command you configure a virtual point-to-point link from a backbone router to a
router of a remote area. The transit areas are the areas that are bridged.
Note
This command is available only with layer 3.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
The address range is advertised outside the areas.
In the backbone area, the router generates an LSA
message of type 5.
If the Area ID is not 0.0.0.0, the router generates
an LSA message of Type 7 in an NSSA.
No LSA messages of type 5 are generated in the
backbone area. The NSSAs connected to the
backbone area generate LSA messages of type 7.
The other areas do not generate any LSA.
Keyword for the P bit. The P bit indicates to the
NSSA-ABR whether the LSA message of type 7 is
translated to type 5.
P bit = 1.
LSA message is translated
P bit = 0.
LSA message is not translated
area
command.
Range of values / note
-
-
-
-
-
command.
no area range
command.
Layer 3 functions
9.3 OSPFv3 (IPv6)
show ipv6 ospf
587