Track Interface - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

You are in the VRRP Router configuration mode.

The command prompt is as follows:

cli(config-vrrp)#

Call up the command with the following parameters:

no interface vlan <vlan-id(1-4094)>

The parameters have the following meaning:

interface-id

For information on names of addresses and interfaces, refer to the section "Interface

identifiers and addresses (Page 42)".

The VRRP interface is deleted.

Further notes

You configure a VRRP interface with the

You display the status and the configuration of the VRRP interface with the

vrrp interface

track interface

With this command, you configure the tracking of interfaces.

When the link of one or more tracked interfaces changes from "up" to "down", the priority of

the assigned VRRP interface is reduced. When the link of the interface changes back from

"down" to "up", the original priority of the VRRP interface is restored.

This command is available only with layer 3.

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

Keyword for a VLAN connection

Number of the addressed VLAN

Module no. and port no. of the interface Enter a valid interface.

Range of values / note

Layer 3 functions

9.4 VRRPv2 (IPv4)