No Distribute Prefix - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.7 RIPng (IPv6)
9.7.3.4

no distribute prefix

Description
This command disables the filtering of the routing information according to an IPv6 address
for incoming or outgoing routing information.
Note
This command is available only with layer 3.
Requirement
You are in the RIPng router configuration mode.
The command prompt is as follows:
cli(config-ripng)#
Syntax
Call up the command with the following parameters:
no distribute prefix <ip6_add> {in | out}
The parameters have the following meaning:
Parameter
ip6_add
in
out
Result
Filtering is disabled.
Further notes
You enable filtering with the
You display the configured filters with the
700
Description
IPv6 address
The filtering for incoming routing information is
disabled.
The filtering for outgoing routing information is
disabled.
distribute prefix
Values
Enter a valid IPv6 address
-
-
command.
command.
show ipv6 rip filter
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11