Commands In The Global Configuration Mode; Loadsave - Siemens SCALANCE XM-400 Configuration Manual

The parameters have the following meaning:
Parameter
filetype
filetype
tftp
ipv4
ucast_addr
fqdn-name
FQDN
ipv6
ip6_addr
port
tcpport
file
filename
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
For information on the file types , refer to this list (Page 109).
Result
The file is saved on the TFTP server.
3.2.4

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
3.2.4.1

loadsave

Description
With this command, you change to the LOADSAVE configuration mode.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Keyword for a file type to be loaded
Name of the file type
Keyword for a TFTP server
Keyword for an IPv4 address
IPv4 unicast address of the TFTP
server
Keyword for a domain name
Domain name (Fully Qualified Domain
Name) of the TFTP server
Keyword for an IPv6 address
IPv6 address of the TFTP server
Keyword for the port of the server via
which the TFTP connection runs
Number of the port
Keyword for a file name to be assigned -
Name of the file
configure terminal
Range of values / note
-
Maximum of 100 characters
-
Enter a valid unicast IPv4 ad-
dress.
-
Maximum of 100 characters
-
Enter a valid unicast IPv6 ad-
dress.
-
1 ... 65535
Maximum of 100 characters
command to change to this mode.
or command and are then in the
end exit
Configuration
3.2 Load and Save
113