Ip Rip Default Route Originate; No Ip Rip Default Route Originate - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Layer 3 functions

9.6 RIPv2 (IPv4)

These commands are available only with layer 3.

ip rip default route originate

This command enables the forwarding of a default route.

● The interface is an IPv4 interface.

● You are in the Interface configuration mode

The command prompt is as follows:

cli(config-if-$$)#

Call up the command with the following parameters:

ip rip default route originate <metric(1-15)>

The parameter has the following meaning:

The default route is forwarded.

This command disables the distribution of the default routes.

Value for the metric information.

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Range of values / note

Configuration Manual, 06/2016, C79000-G8976-C252-11