Show Ipv6 Interface - Siemens SCALANCE XM-400 Configuration Manual

Configuration
3.1 System
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show ip interface [Vlan<vlan-id(1-4094)>]
The parameters have the following meaning:
Parameter
Vlan
vlan-id
interface-type
interface-id
loopback
loopback-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If you do not select any parameter from the parameter list, the configuration is displayed for
all available IPv4 interfaces.
Result
The configuration of the selected IPv4 interface is displayed.
3.1.1.12

show ipv6 interface

Description
This command shows the configuration of one, several or all IPv6 interfaces.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
68
or
cli#
[<interface-type><interface-id>]
[loopback<loopback-id(0)>]
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Module no. and port no. of the interface
Keyword for a loopback
Number of the addressed loopback
or
cli#
Range of values / note
-
1 ... 4094
Enter a valid interface.
-
0
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11