Show Ip Igmp Snooping Groups; Show Ip Igmp Snooping Mrouter - Siemens SCALANCE XM-400 Configuration Manual

Result
The settings are displayed.
8.3.1.4

show ip igmp snooping groups

Description
This command shows information about IGMP snooping for all or a selected VLAN.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode or in the Global
configuration mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show ip igmp snooping groups [Vlan <vlan id> [Group <Address>]] [{static|dynamic}]
The parameters have the following meaning:
Parameter
Vlan
vlan id
Group
Address
-
For information on names of addresses and interfaces, refer to the section "Auto-Hotspot".
Result
The information about IGMP snooping is displayed.
8.3.1.5

show ip igmp snooping mrouter

Description
This command shows the ports at which IGMP queriers are connected for all or a selected
VLAN..
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
or or
cli# cli(config)#
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Layer 2 management protocols
8.3 IGMP snooping
Range of values / note
-
1 ... 4094
•
static
•
dynamic
459