Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ip dhcp relay remote-id <remote-id name>
The parameter has the following meaning:
Parameter
remote-id name
Result
The device ID is specified.
Further notes
You remove the device ID with the
You display the IP addresses with the
You display the settings with the
7.6.3.4
no ip dhcp relay remote-id
Description
With this command, you remove the device identifier.
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
no ip dhcp relay remote-id
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Device ID
no ip dhcp relay remote-id
show dhcp server
show ip dhcp relay information
Network protocols
7.6 DHCPv4 Relay Agent (IPv4)
Range of values / note
max. 32 characters
Default: XYZ
command.
command.
command.
375