Ipv6 Dhcp Client Request - Siemens SCALANCE XM-400 Configuration Manual

Result
The DHCP config file request option is enabled.
Further notes
You enable the option with the
7.4.2.8

ipv6 dhcp client request

Description
With this command you specify which configuration parameters will be requested, e.g. the
IPv6 address of the DNS server.
Requirement
● DHCPv6 Is activated.
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ipv6 dhcp client request {dns-server-address | domain-name | sntp-server-address |
option <code (1-100)>}
The parameters have the following meaning:
Parameter
dns-server-
address
domain-name
sntp-server-
address
option
code
Result
The setting is configured.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
ipv6 dhcp client reconfig-accept
Description
IPv6 address of the DNS server
Domain name
IPv6 address of the SNTP server
Keyword for the option code
Number of the DHCPV6 option
Network protocols
7.4 DHCPv6 client (IPv6)
command.
Range of values / note
-
-
-
-
Enter the required number.
1 ... 200
343