Switchport Priority Default - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Network structures

The parameters have the following meaning:

The operating mode for the private VLAN port is configured.

Further notes

You display this setting and other information with the

You configure the interface as a switch port with the

You configure a host port with the

You configure a promiscuous port with the

switchport priority default

With this command, you configure the priority default for the interface.

You are in the Interface configuration mode.

The command prompt is as follows:

cli(config-if-$$$)#

Call up the command with the following parameters:

switchport priority default <(0-7)>

The parameter has the following meaning:

Configures the port as a promiscuous port.

Promiscuous ports belong to a primary PVLAN. Connect

devices to promiscuous ports that are intended to communi-

cate with all other devices of the PVLAN.

Configures the port as a host port.

Host ports belong to a secondary PVLAN. Connect devices

to host ports that are only intended to communicate with

certain devices of the PVLAN.

switchport private-vlan host-association

Value for the priority default

show vlan port config

switchport private-vlan mapping

Range of values / note

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

Range of values / note

GVRP must be disa-

bled on the port.