No Port-Channel Load-Balance - Siemens SCALANCE XM-400 Configuration Manual

Result
The load balancing policy is set.
Further notes
You can reset the setting for the load balancing policy to the default with the
load-balance
You can display the status of this function and other settings with the
command.
6.2.2.2

no port-channel load-balance

Description
With this command, you reset the load balancing policy for the interconnected ports of the
previously defined port channels to the default.
The default value is
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no port-channel load-balance [<port-channel-index(1-8)>]
The parameter has the following meaning:
Parameter
port-channel-index
If you do not enter a value for
Result
The load balancing policy is reset to the default value.
Further notes
You can change the setting for the load balancing policy with the
command.
You can display the status of this function and other settings with the
command.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
.
src-dest-mac
Description
Number of the port channel
port-channel-index
6.2 Link aggregation
show etherchannel
Range of values / note
1 ... 8
, the setting is used for all port channels.
port-channel load-balance
show etherchannel
Network structures
no port-channel
231