Ip Igmp Static-Group - Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.2 IGMP
Further notes
You configure the setting with the
You display the setting and other information with the
command.
8.2.3.17

ip igmp static-group

Description
With this command, you define a static multicast group. The clients are signed statically and
do not need to log on.
Requirement
You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call up the command with the following parameters:
ip igmp static-group <Group Address> [source <Source Address>]
The parameters have the following meaning:
Parameter
Group Address
source
Source Address
Result
The client is statically assigned to the multicast group.
Further notes
You delete the assignment of a client with the
You display the list of configured multicast groups with the
command.
454
ip igmp robustness
Description
Address of the multicast group
Keyword for a client
IP address of the client
no ip igmp static-group
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
command.
show ip igmp global-config
Range of values / note
-
-
-
show ip igmp group-list
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.