Deny - Siemens SCALANCE XM-400 Configuration Manual

Parameter
dscp
value
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The IP access list has been configured.
Note
Subnet mask for individual hosts
If you create the rule for a single system (one IP address), you will need to specify the
subnet mask "255,255,255,255". As an alternative, you can specify the keyword "host"
followed by the IP address.
Further notes
You delete an IP access control list with the
command.
You display the configuration of the access control list with the
11.4.4.2

deny

Description
With this command, you configure an IP access control list. The IP ACL contains a
description of the IP addresses for which the incoming and outgoing frames will not be
forwarded.
You have the following options:
● All incoming and/or outgoing frames are not forwarded.
● Incoming and/or outgoing frames of a specific host are not forwarded.
● Incoming and/or outgoing frames of hosts of a specific subnet are not forwarded.
● Incoming and/or outgoing frames of a specific protocol are not forwarded.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Keyword for the Differentiated Services
Codepoint
Value for the Differentiated Services
Codepoint
no ip access-list standard <acl-num>
Security and authentication
11.4 IP access control list
Range of values / note
-
0 ... 63
command.
show access-lists
841