Private-Vlan Mapping - Siemens SCALANCE XM-400 Configuration Manual

Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
no map subnet <ip-subnet-address>
The parameter has the following meaning:
Parameter
ip-subnet-address
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The IPv4 subnet was removed.
Further notes
You configure the setting with the
You can display the status of this function and other information with the
mapping
6.1.3.3

private-vlan mapping

Description
With this command you specify from which secondary PVLANs the IP interface of the
primary PVLAN will be reachable.
Requirement
● The interface is configured as an IP interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
IPv4 subnet address
command.
command.
map subnet
Network structures
6.1 VLAN
Range of values / note
Enter a valid subnet address
show subnet-vlan
201