Commands In The Interface Configuration Mode; Dot1X Guest-Vlan - Siemens SCALANCE XM-400 Configuration Manual

Security and authentication
11.7 Port-based Network Access Control (Dot1X)
Result
MAC authentication is disabled for the device.
Further notes
You enable the function with the
You display this setting and other information with the
11.7.3

Commands in the interface configuration mode

This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
Global configuration mode.
● If you exit the Interface configuration mode with the
Privileged EXEC mode.
11.7.3.1

dot1x guest-vlan

Description
With this command, you enable the guest VLAN function for a port.
This function is also known as "Authentication failed VLAN".
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
dot1x guest-vlan
Result
The guest VLAN function is enabled for the device.
870
command.
dot1x mac-auth
show dot1x
command to change to this mode.
interface
exit
end
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
command, you return to the
command, you return to the