Show Ip Ospf - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.2 OSPFv2 (IPv4)
The parameters have the following meaning:
Parameter
area-id
database-summary
self-originate
adv-router
ip-address
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The summary of the database is displayed.
9.2.1.4 show ip ospf ... database ...
Description
This command shows information about a specific or all LSA types.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:

show ip ospf

[area-id]
database
[link-state-id]
[{
}]
514
Description
Area-ID
Number of LSA types per area and the
total number of areas
Number of LSAs generated by the local
router.
Keyword for the router-specific LSA
shows the router-specific LSA for a
specific IP address
or
cli#
{
asbr-summary|external|network|
nssa-external|router|summary
}
adv-router <ip-address>|self-originate
Range of values / note
specify an ID.
x.x.x.x
x = 0 ... 255
0.0.0.0 = backbone area
-
-
specify a valid IP address.
If no IP address is entered, the
specific LSAs of the local router
are displayed.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11