Further notes
You enable the function with the
You configure the threshold value for the storm control function with the
command.
10.1.2.4
no storm-control
Description
With this command, you disable the storm control function for broadcast, multicast or
unknown unicast packets.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
no storm-control{broadcast|multicast|dlf}
The parameters have the following meaning:
Parameter
broadcast
multicast
dlf
if you call up the function without parameters, it is disabled for all types of transmission.
Result
The storm control function is disabled.
Further notes
You enable the function with the
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
no storm-control
Description
Disables broadcast storm control
Disables multicast storm control
Disables unknown unicast storm control
command.
storm-control
Load control
10.1 Rate control
storm-control level
779