No Gvrp - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Further notes

If you have enabled the GARP module, you start GVRP explicitly with this command.

If you want to disable the function for a specific interface on the device, use the

You can display the status of this function and other information with the

no gvrp

With this command, you disable the GVRP function for all or individual interfaces on the

You are in the Global configuration mode

You are in the Interface configuration mode

The command prompt is as follows:

cli(config)#

cli (config-if-$$$) #

Call the command without parameters:

In the Global configuration mode: The GVRP function is disabled on the device.

In the Interface configuration mode: The GVRP function is disabled for this interface.

Further notes

If you want to enable the function for a specific interface on the device, use the

You can display the status of this function and other information with the

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

Layer 2 management protocols

show vlan device

show vlan device