The "Show" Commands; Show Running-Config - Siemens SCALANCE XM-400 Configuration Manual

3.4.2

The "show" commands

This section describes commands with which you display various settings.
3.4.2.1

show running-config

Description
This command shows configuration settings of the device.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show running-config
[{
syslog|dhcp|qos|stp|la|dot1x|vlan<vlan-id(1-4094)>|
interface
ssh|ssl|acl|ip|snmp|radius|rmon|igmp|sntp|http|
broadcast-blocking|multicast-blocking|locked-port|auto-logout|
time|ntp|auto-save|panel-button|cos-map|dscp-map|
output-rate-limit|unicast-blocking|ospf|vrrp|loopd|events|
redundancy|passive|umac|nat|fmp|pim|router-advertisement-blocking}]
[all]
The parameters have the following meaning:
Parameter
syslog
dhcp
qos
stp
la
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
or
cli#
{port-channel<port-channel-id(1-8)>|
<interface-type><interface-list>|
vlan<vlan-id(1-4094)>
}|
Description
Shows the configuration settings of the
Syslog function
shows the configuration settings of the
Dynamic Host Configuration Protocol
shows the configuration settings of
QoS (Quality of Service)
Shows the configuration settings of the
Spanning Tree protocol
Shows the configuration settings of the
Link Aggregation function
Configuration
3.4 Configuration Save & Restore
Range of values / note
-
-
-
-
-
123