Commands In The Global Configuration Mode; Arp - Siemens SCALANCE XM-400 Configuration Manual

Network protocols

7.12 ARP

Syntax
Call up the command with the following parameters:
show ip arp [{Vlan<vlan-id(1-4094)>|<interface-type><interface-id>|
The parameters have the following meaning:
Parameter
Vlan
vlan-id
interface-type
interface-id
ip-address
mac-address
summary
information
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If you do not select any parameter from the parameter list, the IP ARP table is displayed.
Result
The IP ARP table is displayed.
7.12.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
7.12.2.1 arp
Description
With this command, you generate a static entry in the ARP cache.
424
<ip-address>|<mac-address>|summary|information}]
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Module no. and port no. of the interface
Shows the IP addresses of the entries
in the ARP table
Shows the MAC addresses of the en-
tries in the ARP table
Shows a summary of the entries in the
ARP table
Displays information on the ARP con-
figuration
configure terminal
Range of values / note
-
1 ... 4094
Enter a valid interface.
-
-
-
-
command to change to this mode.
or command and are then in the
end exit
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11