No Arp - Siemens SCALANCE XM-400 Configuration Manual

Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
arp <ip address> <hardware address> {Vlan <vlan-id(1-4094)> | <interface-type>
<interface-id> | Cpu0}
The parameters have the following meaning:
Parameter
ip address
hardware address
Vlan
vlan-id
interface-type
interface-id
Cpu0
For information on addresses and interfaces, refer to the section "Addresses and interface
names (Page 44)".
Result
The entry is generated in the ARP cache.
Further notes
You delete a static entry from the ARP cache with the
You can display the status of this function and other information with the
command.
You configure the router port with the
7.12.2.2

no arp

Description
With this command, you delete an entry from the ARP cache.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Value for the IP address to be linked to
a device (physical address)
Physical address that will be linked
with the IP address
Keyword for a VLAN connection
Number of the VLAN
Type or speed of the interface
Module no. and port no. of the interface
The interface is configured as "Out-of-
band management interface"
no switchport
Network protocols
Range of values / note
IP address or IP alias
MAC address of the device
-
1 ... 4094
Enter a valid interface.
-
command.
no arp
show ip arp
command.
7.12 ARP
425