Interface - Siemens SCALANCE XM-400 Configuration Manual

Configuration
3.1 System
Result
EtherNet/IP is enabled or disabled after the next restart.
Further notes
You can display the current EtherNet/IP configuration with the
You restore the default settings of the EtherNet/IP profile with the
3.1.12.7

interface

Description
With this command, you change to the Interface configuration mode.
There you can edit the settings for one interface. You select the interface with the
parameters of this command. If you specify a logical interface that does not exist, it will be
created. The name of the selected interface is displayed in the command prompt.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
interface{cpu0|vlan<vlan-id(1-4094)>|port-channel<port-channel-id(1-8)>|
The parameters have the following meaning:
Parameter
cpu0
vlan
vlan-id
port-channel
port-channel-id
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
86
<interface-type><interface-id>}
Description
The configuration mode for the "Out of
Band Management interface" is called
up
Keyword for a VLAN connection
Number of the addressed VLAN
Keyword for a port channel connection
Number of the addressed port channel
Type or speed of the interface
Module no. and port no. of the interface
show ethernetip
restart
Range of values / note
-
-
1 ... 4094
-
1 ... 8
Enter a valid interface.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
command.