Configuration
3.5 PoE
Further notes
You configure the user-defined maximum power for the interface with the
command.
You enable the user-defined maximum power for the interface with the
active
You disable the user-defined maximum power for the interface with the
maxpwr active
3.5.3.5
poe custom maxpwr active
Description
With this command, you enable use of the user-defined maximum power for the interface.
Requirement
You are in the Interface Configuration mode of a PoE interface.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
poe custom maxpwr active
Result
The user-defined maximum power is enabled for the relevant interface.
Further notes
You configure the user-defined maximum power for an interface with the
command.
You disable the use of the user-defined maximum power with the
active
3.5.3.6
no poe custom maxpwr active
Description
With this command, you disable use of the user-defined maximum power for the interface.
136
command.
command.
command.
no poe custom maxpwr
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
poe custom maxpwr
poe custom maxpwr
no poe custom
poe custom maxpwr