Show Multicast-Block Config - Siemens SCALANCE XM-400 Configuration Manual

Syntax
Call up the command with the following parameters:
show ipv6 interface [{vlan <id> | <interface-type> <interface-id>} [prefix]]
The parameters have the following meaning:
Parameter
vlan
id
interface-
type
interface-id
prefix
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If you do not select any parameter from the parameter list, the configuration is displayed for
all available IPv6 interfaces.
Result
The configuration is displayed.
Further notes
You enable IPv6 on the VLAN interface or on the router port with the
You configure an IPv6 address with the
3.1.1.13

show multicast-block config

Description
This command shows the multicast blocking settings for ports.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show multicast-block config [port <interface-type> <interface-id)>]
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Module no. and port no. of the interface
shows the prefix information of the IPv6 interface
or
cli#
command.
ipv6 address
Configuration
3.1 System
Range of values / note
-
1 ... 4094
Enter a valid interface
-
command.
ipv6 enable
69