Show Fmp Status - Siemens SCALANCE XM-400 Configuration Manual

Diagnostics
12.2 FMP
The parameters have the following meaning:
Parameter
interface
interface-type
interface-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If no parameters are specified, the settings for all interfaces are displayed.
Result
The limits set for the received power and the power loss are displayed.
12.2.1.2

show fmp status

Description
This command shows the current status and the current values of the optical ports or
connections that you monitor with fiber monitoring.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show fmp status [{interface <interface-type> <interface-id>}]
The parameters have the following meaning:
Parameter
interface
interface-type
interface-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If no parameters are specified, the settings for all interfaces are displayed.
906
Description
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
or
cli#
Description
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
Range of values / note
-
Enter a valid interface.
Range of values / note
-
Enter a valid interface.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11