Pnio - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Configuration

The parameters have the following meaning:

port-channel

port-channel-id

For information on addresses and interfaces, refer to the section "Addresses and interface

names (Page 42)".

The logical interface is deleted.

Further notes

You configure an interface with the

You display the status and the configuration of the interfaces with the

pnio

With this command, you configure the setting for PROFINET after the next restart of the

You are in the Global configuration mode.

The command prompt is as follows:

cli(config)#

Call up the command with the following parameters:

pnio {off|on}

Keyword for a VLAN connection

Number of the addressed VLAN

Keyword for a port channel connection

Number of the addressed port channel

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Range of values / note

show interfaces

Configuration Manual, 06/2016, C79000-G8976-C252-11