Layer 3 functions
9.9 NAT (IPv4)
You configure static port translations for an interface with a port range with the
service portrange
You display the current configuration with the
9.9.3.8
no ip nat service
Description
With this command you delete static port translations (NAPT) for an interface with a service.
Requirement
You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
no ip nat service {{<inside local ip> <inside local port number> [{ tcp | udp | any
}]} | all}
The parameters have the following meaning:
Parameter
inside local ip
inside local port
number
Protocol
all
Result
The static port translation with a service is deleted.
Further notes
You configure static port translations with a service for an interface with the
command.
You configure static port translations for an interface with a port range with the
service portrange
You display the current configuration with the
748
command.
Description
Actual address of the device that
is reachable from external.
Port that is assigned to the inside
local address.
Protocol for which the port trans-
lation is valid.
Deletes all port translations
command.
command.
show ip nat service
Range of values / note
Enter a valid IPv4 address.
-
•
tcp
•
udp
•
any
-
command.
show ip nat service
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
ip nat
ip nat service
ip nat