Area Range - Ipv6Prefix/Prefix_Length - Siemens SCALANCE XM-400 Configuration Manual

Parameter Description
virtual-link
Virtual link
router-id
ID of the router
default-metric
Metric of the standard route
range
Address range
summary
LSA type 3
Type7
LSA type 7
summary-prefix
Address range of external
routes
IPv6-Prefix
IPv6 address
Prefix-Length
Number of bits belonging to the
prefix
(from left to right)
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The area is removed or changed.
9.3.3.3

area range - ipv6prefix/prefix_length

Description
With this command, you assign an area ID an address range. The address range is used to
group the routes within OSPFv3.
Note
This command is available only with layer 3.
Requirement
● The router is an area border router
● You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Range of values / note
-
Specify the ID in the IPv4 address format
x.x.x.x = 0 ... 255
-
-
-
-
-
Enter a valid IPv6 address
1 ... 128 bits
128: The node (host) itself
Layer 3 functions
9.3 OSPFv3 (IPv6)
581