Layer 3 functions
9.4 VRRPv2 (IPv4)
9.4.4.14
vrrp track decrement
Description
With this command you assign a VRRP interface to an interface tracking and configure the
value by which the priority is reduced.
Note
This command is available only with layer 3.
Requirement
You are in the VRRP Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-if)#
Syntax
Call up the command with the following parameters:
vrrp <vrid(1-255)> track <group-index> decrement <integer(1-254)>
The parameters have the following meaning:
Parameter
vrid
group-index
integer
Result
A VRRP interface is assigned to interface tracking. The value by which the priority will be
reduced is defined.
Further notes
You delete the configuration with the
You display the assignment and value of the priority with the command
or
show vrrp interface - vrid
You configure the tracking of interfaces with the
644
Description
ID of the virtual router
ID of the interface tracking
Value by which priority of the VRRP inter-
face will be reduced
no vrrp track
with the parameter
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
1 ... 255
-
1 ... 254
command.
.
detail
command.
track interface
Configuration Manual, 06/2016, C79000-G8976-C252-11
show vrrp interface