No Mac-Address-Table Static Multicast - Siemens SCALANCE XM-400 Configuration Manual

Syntax
Call up the command with the following parameters:
mac-address-table static multicast <aa:aa:aa:aa:aa:aa>
[forbidden-ports([<interface-type><0/a-b,0/c,...>]
The parameters have the following meaning:
Parameter
aa:aa:aa:aa:aa:aa
vlan
vlan-id
interface
interface-type
0/a-b, 0/c,...
port-channel
forbidden-ports
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The entry in the forwarding database is generated.
Further notes
With the
configured entries.
With the
10.2.1.3

no mac-address-table static multicast

Description
With this command, you delete a static multicast MAC address entry from the forwarding
database.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
vlan<vlan-id(1-4094)>
interface([<interface-type><0/a-b,0/c,...>]
[<interface-type><0/a-b,0/c,...>]
[port-channel<1-8>]])
[<interface-type><0/ab,0/c, ...>]
[port-channel <1-8>]])
Description
MAC address of the interface
Keyword for a VLAN connection
Number of the addressed VLAN
Keyword for a an interface description
Type of interface
Module no. and port no. of the interface
Specifies the name of a port channel
Keyword for the interface description of
the blocked ports
show mac-address-table static multicast
no mac-address-table static multicast
10.2 Static MAC filtering
Range of values / note
-
-
1 ... 4094
-
Enter a valid interface.
1-8
-
command, you display the list of
command, you delete an entry.
Load control
783