Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameter assignment:
show ipv6 ospf host
Result
The host table is shown.
9.3.1.6
show ipv6 ospf interface
Description
This command shows the information on the OSPFv3 interface.
Note
This command is available only with layer 3.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show ipv6 ospf interface
[{
vlan<vlan-id(1-4094)>|<interface-type><interface-id>
}]
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
or
cli#
or
cli#
Layer 3 functions
9.3 OSPFv3 (IPv6)
571