Further notes
You configure the setting with the
You display the setting with the
10.3.2.3
mac-address-table aging
Description
With this command, you enable the "Aging" function. The "Aging" function ensures that an
entry in the MAC address list that was learned dynamically is deleted again after a certain
time.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
mac-address-table aging
Result
The "Aging" function is enabled.
Further notes
You configure the time with the
You disable the "Aging" function with the
10.3.2.4
no mac-address-table aging
Description
With this command, you disable the "Aging" function.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
mac-address-table aging-time
show mac-address-table aging-time
mac-address-table aging-time
no mac-address-table aging
Load control
10.3 Dynamic MAC aging
command.
command.
command.
command.
791