Unicast-Block - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

● The interface is disabled with the

● You are in the Interface configuration mode.

The command prompt is:

cli(config-if-$$$)#

Call the command without parameters:

no switchport

The interface is configured as a router port.

The command prompt is as follows:

cli(config-if_RPort-Gi$$$)#

Activate the interface again with the

Further notes

You shut down the interface with the

You activate the interface with the

You configure the interface as a switch port with the

You can display the status of this function and other information with the

unicast-block

With this command, you enable the blocking of unknown unicast frames on an interface.

You are in the Interface configuration mode.

The command prompt is as follows:

cli(config-if-$$$)#

Call the command without parameter assignment:

unicast-block

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

Configuration