Siemens SCALANCE XM-400 Configuration Manual page 320

Network protocols
7.2 IPv6 protocol
● In DHCPv6 the stateless DHCPv6 autoconfiguration or prefix delegation is enabled.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ipv6 address <PD Name> <prefix> <prefix Len>
or
ipv6 address <prefix> <prefix Len> [{unicast | anycast | eui64}]
or
ipv6 address <ipv6prefix/prefix_length> [{unicast | anycast | eui-64| linklocal}]
The parameters have the following meaning:
Parameter
PD Name
prefix
ipv6prefix
prefix Len
/prefix_length
unicast
anycast
eui64
eui-64
linklocal
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The IPv6 address is assigned to the interface.
Further notes
You delete the IPv6 address with the
You enable IPv6 with the
You display this setting and other information with the
320
Description
Prefix Name
The PD router stores IPv6 prefix of the
DHCPv6 server under this name.
IPv6 address
Number of bits belonging to the prefix
(from left to right)
Addressing mode unicast
Addressing mode anycast
Interface ID according to the EUI-64
method
Link local address
no ipv6 address
command.
ipv6 enable
Range of values / note
Enter the prefix name.
Requirement: Prefix delegation is ena-
bled.
Enter a valid IPv6 address
1 ... 128 bits
64: With EUI-64
128: The node (host) and with link-
local addresses
-
-
-
-
command.
show ipv6 interface
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.