Spanning-Tree Mst Pseudorootid - Siemens SCALANCE XM-400 Configuration Manual

Further notes
You can configure the setting for the hello time with the
command.
You display this setting and other information with the commands that start with
spanning tree ...
6.3.5.20

spanning-tree mst PseudoRootId

Description
With this command, you configure a pseudoroot MAC address and the priority for a spanning
tree configuration. The command is used in conjunction with the layer 2 gateway port.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
spanning-tree[mst<instance-id>]pseudoRootId
The parameters have the following meaning:
Parameter
mst
instance-id
priority
value
mac-address
ucast_mac
You can only change the value for the priority in the steps of 4096.
Result
The pseudoroot MAC address and the priority are configured.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
.
priority<value(0-61440)>mac-address<ucast_mac>
Description
Keyword for a spanning tree instance
Number of the instance
Keyword for the priority
Value for the priority
Keyword for the pseudoroot unicast
MAC address
MAC address of the interface
Network structures
6.3 Spanning Tree
spanning-tree mst hello-time
Range of values / note
-
1 ... 64
-
0 ... 61440
Default:
Priority of the device
-
aa:aa:aa:aa:aa:aa
Default:
MAC address of the device
show
273