No Switchport Map Protocols-Group; Switchport Mode - Siemens SCALANCE XM-400 Configuration Manual

6.1.3.10

no switchport map protocols-group

Description
With this command, you delete the assignment of a configured protocol group to a specific
VLAN.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
no switchport map protocols-group <group id(0-2147483647)>
The parameter has the following meaning:
Parameter
group id
Result
The assignment is deleted.
Further notes
You assign a protocol group and a VLAN to an interface with the
group
You can display the status of this function and other information with the
protocols-group
6.1.3.11

switchport mode

Description
With this command, you specify the operating mode for the switch port.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Number of the group
command.
command.
Network structures
6.1 VLAN
Range of values / note
0 ... 2147483647
switchport map protocols-
show vlan
207