Port-Based Network Access Control (Dot1X); The "Show" Commands; Show Dot1X - Siemens SCALANCE XM-400 Configuration Manual

Result
An authorized manager is deleted from the list.
Further notes
You configure the interfaces and protocols via which an authorized manager is allowed to
access the device with the
You show the information about the configuration of the authorized managers with the
authorized-manager
11.7

Port-based Network Access Control (Dot1X)

This section describes commands for working with port-based network access control
(PNAC).
11.7.1

The "show" commands

This section describes commands with which you display various settings.
11.7.1.1

show dot1x

Description
This command shows information about port-based network access control (PNAC).
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show dot1x[{interface<interface-type><interface-id>|
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
authorized-manager ip-source
command.
or
cli#
statistics interface<interface-type><interface-id>}]
Security and authentication
11.7 Port-based Network Access Control (Dot1X)
command.
show
865