No Mac-Address-Table Static Unicast - Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.7 Multicast
8.6.2.2

no mac-address-table static unicast

Description
With this command, you disable the "static unicast" function.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no mac-address-table static unicast <aa:aa:aa:aa:aa:aa> vlan <vlan-id(1-4094)>
The parameters have the following meaning:
Parameter
aa:aa:aa:aa:aa:aa
vlan
vlan-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If you do not select any parameters from the parameter list, the default value is used.
Result
The "static unicast" function is disabled.
Further notes
You activate the setting with the
490
Description
MAC address
Keyword for a VLAN connection
Range of values of the VLAN
no mac-address-table static unicast
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
Specify a valid MAC address.
-
1 ... 4094
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.