Layer 3 functions
9.10 PIM (IPv4)
Result
The device is a static rendezvous point.
Further notes
You delete the configuration with the
You specify the interfaces for static rendezvous points with the
command.
You display the static rendezvous points with the
9.10.3.5
no ip pim static-rp
Description
With this command, you delete the configuration of the device as a static rendezvous point.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ip pim static-rp
Result
The device is not a static rendezvous point.
Further notes
You configure the device as a rendezvous point with the
You specify the interfaces for static rendezvous points with the
command.
You display the static rendezvous points with the
764
command.
no ip pim static-rp
show ip pim rp-static
ip pim static-rp
show ip pim rp-static
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
rp-static rp-address
command.
command.
rp-static rp-address
command.