No Ipv6 Ospf Passive-Interface; Ipv6 Ospf Priority - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.3 OSPFv3 (IPv6)
9.3.4.10

no ipv6 ospf passive-interface

Description
With this command, you enable the OSPFv3 interface.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
no ipv6 ospf passive-interface
Result
The OSPFv3 interface "" is enabled.
Further notes
You enable OSPFv3 routing with the
You deactivate the OSPFv3 interface with the
You display the configuration with the
9.3.4.11

ipv6 ospf priority

Description
With this command, you specify the router priority. The designated router is identified based
on the priority.
Note
This command is available only with layer 3.
610
command.
ipv6 router ospf
ipv6 ospf passive-interface
show ipv6 ospf interface
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
command.