Dhcpv4 Relay Agent (Ipv4); The "Show" Commands; Show Dhcp Server; Show Ip Dhcp Relay Information - Siemens SCALANCE XM-400 Configuration Manual

Network protocols

7.6 DHCPv4 Relay Agent (IPv4)

7.6 DHCPv4 Relay Agent (IPv4)
This section describes commands for the DHCP Relay Agent.
7.6.1

The "show" commands

This section describes commands with which you display various settings.
7.6.1.1

show dhcp server

Description
With this command, you display the IP addresses of the DHCP servers to which the device
forwards the frames.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode or in the Global
Configuration mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show dhcp server
Result
The IP addresses of the DHCP servers are displayed.
Further notes
With the "
7.6.1.2

show ip dhcp relay information

Description
This command displays the DHCP relay agent settings for all or for a selected VLAN.
366
or
cli#
" command, you specify the IP addresses.
ip dhcp server
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11