No Syslogserver - Siemens SCALANCE XM-400 Configuration Manual

Diagnostics
12.6 Syslog Client
Result
The settings for the Syslog server are configured. The Syslog server was entered in the
table.
Further notes
You delete the entry with the
You can display the status of this function and other information with the
command.
12.6.2.2

no syslogserver

Description
With this command, you delete a Syslog server.
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call up the command with the following parameters:
no syslogserver { ipv4 <ucast_addr> | fqdn-name <FQDN> | ipv6 <ip6_addr>}
The parameters have the following meaning:
Parameter
ipv4
ucast_addr
fqdn-name
FQDN
ipv6
ip6_addr
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The Syslog server is deleted.
Further notes
You add a Syslog server with the
946
command.
no syslogserver
Description
Keyword for an IPv4 address
IPv4 unicast address of the Syslog
server
Keyword for a domain name
Domain name (Fully Qualified Domain
Name)
Keyword for an IPv6 address
IPv6 address of the Syslog server
syslogserver
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
-
Enter a valid IPv4 address.
-
Maximum of 100 characters
-
Enter a valid IPv6 address.
command.
Configuration Manual, 06/2016, C79000-G8976-C252-11
show events config